 Tube quality inspection Tube quality inspection Using traditional contact detection method to inspection turbines, the inspection efficiency is slow; the amount of inspection data is small, only a limited number of points can be detected; each time it must be placed in a fixed position to inspect, the operation is inconvenient;and the inspection cost is increased. After using XTOM 3D optical surface scanning system, the whole turbine surface can be scanned quickly. By comparing the scanning results with the CAD model, all the data on the turbine surface can be detected. The measurement results are rich and accurate. Use equipment XTOM-ET 6M Use equipment Measurement process The surface of the turbine is treated, the imaging agent is sprayed, the marking points are pasted and placed on the worktable. XTOM is used for scanning and data splicing automatically. Comparing the scanned data with the design model in Geomagic Qualify software and setting the corresponding tolerance, the corresponding test results can be obtained and the test report can be output. |